Water got into your phone speaker - what to do first?
If water or other liquid gets into the speaker, you can take the phone to a service center or use traditional methods to dry the speaker.
- First of all, you need to remove the battery from the mobile device and do not put it back for at least a day. It is worth remembering that the elements inside the phone are killed not so much by moisture as by electricity, which oxidizes the parts inside. This leads to failure of the radio elements of the mobile phone.
- Next, you need to try to remove moisture from inside the device. To do this, you can put your phone in a bowl of rice for a day, but you need to completely cover the mobile phone with cereal. Rice has the ability to draw out moisture. You can dry your mobile phone with a hairdryer, but here you need a slightly warm stream of air, and you need to act very carefully.
- You can use special applications to remove liquid from phones. In this case, sounds are produced at high frequencies, which push the water out.
Of course, these methods do not always work, and the phone continues to work incorrectly. In this case, it is recommended to contact a service center and entrust the repair to specialists. It is worth considering that the sooner you contact us, the less the repair will cost. And in some cases, just preventing the elements of a mobile device is enough.
https://www.youtube.com/watch?v=AqqKWi46Mt8
How to replace the speaker if you can’t clean it
It is recommended that the connector replacement procedure be carried out with appropriate experience. This can be done at home using the following algorithm:
- Disassemble your smartphone. To do this, you will need to remove the back wall using a thin blade and unscrew the screws using a small screwdriver.
- Using a soldering iron, remove the old microphone. The device is removed using a blade, which must be slipped under the heated “legs”.
- Clean the microcircuit with alcohol to remove microphone residues.
- Using a soldering iron and solder, a new microphone is attached to the same place.
- Lightly press the microphone onto the chip and solder the protruding wires.
It is recommended to carry out the described manipulations quickly. If the microcircuit overheats, the mobile device may fail. Once the replacement is complete, remove excess solder by wiping the device with alcohol. Finally, you need to check the functionality of the microphone, then tighten the screws and put the back cover in place.
What you should absolutely not do
Some smartphone owners, after their mobile phone gets wet, begin to panic and do everything they have ever heard of, in the hope of drying out the device. So, there are things that you absolutely cannot do, as you can permanently damage your mobile phone.
- Do not dry a wet smartphone with a hot hairdryer. In this case, the contacts may melt and the mobile phone will not work. For drying, you can only use a hair dryer with a cold stream of air, and you need to blow from a distance. Alternatively, you can use a bicycle pump or even an inflated balloon;
- Don't shake your phone. In this case, you won’t remove a lot of water, but you can make the situation worse. It is better to carefully tilt the device to the side where there are holes so that the water flows out;
- You should not put your mobile phone in salt to remove moisture. The grains will get inside the device, and it will be completely disabled. You cannot use small rice to remove moisture, since the grain may get stuck in the technological holes;
- You cannot put a wet mobile phone in sugar, as water and sugar create a sticky syrup that will lead to damage to the gadget;
- You should not try to disassemble a mobile phone yourself. Most likely, you do not have the skills and tools for such disassembly, so during the disassembly process there is a chance of further damaging your mobile phone.
In addition, you should not try to dry a mobile phone with the battery inserted. The battery must be removed immediately and the device must be dried without it for at least a day.
You should not try to revive your smartphone yourself if it is under warranty. In many cases, after self-repair, the seller disclaims warranty obligations.
How to dry the speaker on your phone correctly
It is best to dry a wet mobile phone in some substance that can draw out and absorb moisture. In any case, you need a deep container where you can pour the adsorbent and put your smartphone.
- The easiest way is to put the gadget with the back cover and battery removed in rice; the device should be completely covered with cereal. The phone needs to be kept in the rice for a couple of days, turning it over every 12 hours. This method is quite effective, the main thing is to take large rice so that it does not get stuck in the holes of the smartphone.
- Use silica gel cat litter. This is an ideal solution for drying a wet smartphone. The gadget with the back cover and battery removed is placed in the filler and covered with it. To prevent particles of the substance from getting inside the device, it is recommended to wrap the mobile phone in two layers of gauze.
- You can also dry your device in silicone balls, which are found in shoe boxes and new bags. You need a lot of these balls, but in just two days they will effectively draw out the water.
- You can put a wet smartphone on the windowsill, in the sun. In addition, you can put it in any warm place for a couple of days, but first you need to remove the battery.
- You can use a vacuum cleaner for drying; it will help draw out excess moisture. For this purpose, it is better to use a vacuum cleaner with power control. Another option is to use a compressor.
In any case, the mobile device must be taken out every 6 hours and any moisture that has appeared must be wiped off with paper napkins; this must be done carefully, blotting the surface.
If the mobile phone gets very wet, the adsorbent will have to be replaced with a new one several times.
What to do after drying
After drying the phone, insert the battery back and try to turn on the mobile device. They check how correctly the mobile phone works; to do this, you need to call someone and listen to how the speaker works. It doesn’t hurt to clarify with your interlocutor how he hears you.
You need to understand that a wet mobile phone can start to fail even after a while. But this does not always happen; it may well be that the mobile phone will serve faithfully for a long time.
If a mobile device has been lying in water for a long time, then, as a rule, it cannot be restored. In this case, it can be sold for spare parts, but the cost will be minimal.
How to clean your phone speaker at home
As usual, it is better to do this periodically, without waiting for critical consequences. Moreover, it takes very little time to clean. You will need quite ordinary and affordable components: alcohol, cotton swabs, a toothbrush with thin bristles and masking tape, as well as transparent tape.
- Exploitation
7 ways to quickly clean grease from your microwave
If all else fails
If none of the above methods helped and the phone does not turn on or does not work correctly, then all that remains is to contact the service center. You should carefully choose a phone repair shop. It is better to listen to the recommendations of acquaintances and friends. As a last resort, you can read reviews on the Internet.
If the mobile phone was purchased relatively recently and is covered by a warranty, then you should not even try to repair anything yourself. In this case, you just need to take the phone to one of the addresses specified in the warranty card.
How to save your phone from moisture
To prevent your smartphone from getting wet and damaged, you must follow these recommendations:
- Do not use a mobile device while eating or drinking tea. In this case, there is a high chance of dropping your mobile phone into a bowl of soup or a mug of tea;
- Do not use your smartphone in the bathroom. Even if you are not talking on the phone while sitting in the bathroom, it is still in a room with high humidity, which negatively affects electronic elements;
- No need to make and receive calls during the rain. You can wait a couple of minutes until you go to the store or get home;
- You should not carry your mobile device in your pockets in summer. At this time of year, the body sweats a lot, which can lead to your cell phone getting wet;
- The mobile phone should be placed in a place where water cannot be accidentally spilled on it.
These seem to be all the rules for careful handling of a mobile device. You can also recommend using covers and protective glasses. They will not save you from getting very wet, but they will be able to retain a small amount of water.
Tatiana
I follow news on the mobile services market. Always up to date with the latest events
Ask a Question
Question to the expert
A few days ago I got caught in the rain, the phone was in the back pocket of my trousers, it didn’t get very wet, but it was damp. When I got home I put it in a warm place. It worked fine right away, but now it’s started to glitch, what’s the reason?
Most likely, the reasons lie in the oxidation of wires and microcircuits. The mobile phone should be taken to a service center where it will be cleaned. If you have the skills to disassemble mobile phones and have special tools, you can disassemble the device yourself and wipe all parts with medical alcohol.
I accidentally spilled sweet tea on my iPhone, what should I do?
I accidentally spilled sweet tea on my iPhone, what should I do?
I dropped my smartphone into a bathtub of water, but got it out instantly. I took out the battery and left it to dry in rice for two days, as recommended. After that I inserted the battery, but the phone does not turn on. What to do?
You will have to take your mobile phone in for repair. Most likely, the contacts and microcircuits have oxidized.
4.5 / 5 ( 29 votes)
0
Author
Tatiana
I follow news on the mobile services market. Always up to date with the latest events
What to do if your phone is in water
Unfortunately, not every device can be saved in such a situation. Everything largely depends on exactly how much water got into the gadget. It is also important to take into account that not all smartphones have removable parts, which further complicates the process of drying the gadget.
But, regardless of the situation, it is recommended to follow these steps:
- Turn off your phone immediately. Conducting current through any electrical component while it is wet is bound to cause even more serious problems due to water conductivity. However, water getting into an electrical circuit is not the worst thing, like the consequences of getting the active circuit wet.
- In case of contact with any other liquid (soap solution, salt water, beer or other liquids), it is important to wipe the device with a damp cloth. You can also use a slightly dampened cloth. Of course, the phone will get wet in this case, but any liquid, if it is not clean water, will certainly lead to corrosion of the device parts.
- Remove all removable parts. That is, it is important to remove the memory card, SIM card and battery. When removing all these components, it is important to do everything as carefully as possible so as not to touch the speaker or shake it during the removal process.
- Wipe the phone with a soft towel. You can also use a paper towel for this purpose, but it is important to make sure that you use a lint-free cloth. And you need to wipe the phone so that the liquid does not penetrate into the gadget itself. You can also wipe off all previously removed parts of the phone.
- Place the gadget in a dry place, preferably not on a hard surface, but on a soft towel. It is extremely important to leave the phone alone until it is completely dry.
- Wait until the phone dries and then try to turn on the phone. The usual, classic period in such a situation is 1-2 days.
- Assess the damage caused. Maybe you'll be lucky and it will be absolutely fine. In some cases it may not function properly. You need to check the quality of the phone after a couple of days. When testing, you can launch your most important applications, call others and listen to music.
All of these steps can help fix your phone if it has been damaged by water.