How to dry a wet phone - expert advice

First actions when the phone fell into the water

A phone that has fallen into water must be immediately removed and turned off. Press the power button, wait until it turns off, remove the battery. Next steps:

We take out the headphones.
Remove the tube from the case.
We take out SIM cards and a memory card.

Removing the battery will slow down oxidative reactions that occur in a humid environment. They damage electronic components and corrode thin conductive traces on the printed circuit board.

Smartphones of recent years use non-removable batteries. You will not be able to remove the battery yourself. The maximum that the user can do is turn off the device with the power button and follow the above steps. We strongly recommend that you take this handset to a service center as soon as possible. There is a very dense arrangement of elements here, it will be difficult to remove water yourself.

Attention - do not remove the phone connected to charging from the water. First, unplug the charger from the outlet, then remove the handset. Performing actions in reverse order will result in an electric shock.

What to do if your touch phone gets wet

Before proceeding with any actions, you must immediately turn off the gadget. For phones with a non-removable battery, this can be done by long pressing the lock button. Otherwise, simply remove the battery - this way you will avoid a short circuit, otherwise even a service center will not be able to restore the device’s functionality. Then follow these instructions on how to dry the gadget:

Disassemble the device. Ideally, each part should be dried separately: remove the SIM and MicroSD cards. Remove the covers, protective glass and back cover. There is no point in unscrewing everything down to the screws; it will be difficult to put the device back together, so if you have a monoblock model (with a non-separable case), stop at removing all inserted cards. Use screwdrivers only if you are sure that you know the gadget's structure well.
Place the device with the screen facing up. Let gravity do its thing and allow water to accumulate at the bottom of the gadget.
Absorb moisture with paper towels or napkins where possible. Turn the device slightly so that any accumulated liquid flows out through the holes. At the same time, avoid sudden movements and do not shake the gadget in the hope of drying it faster, otherwise water will flow inside again and flood hard-to-reach places.

Keep in mind that turning on the device immediately after you have wiped the surface is strictly prohibited. The most important and final stage is drying the phone after water. Depending on which method is chosen, this will take a different amount of time.

New measures for residents of the Moscow region with signs of ARVI
Omron inhaler
Allergy to gel polish

You can dry the phone by leaving the device in the air for 3–7 days, but this is long and does not guarantee further operation, since radioelements oxidize under the influence of liquid. Use an absorbent substance to help draw water out of the device and dry it faster.

How to dry your phone

To help dry a gadget that has fallen into water:

Rice cereal;
Cat litter;
Silica gel.

Rice absorbs moisture well, in our case it will act as an absorbent. Pour some rice into a bowl, put a pipe in it, and add a small amount of cereal. Leave the phone for 15-20 hours. Regular rice that has not been steamed absorbs moisture best. It is recommended to cover the bowl with a lid that does not allow air to pass through.

Cat litter is an excellent absorbent. Take a portion of the filler and place the sunken phone in it. The cost of the smallest pack is from 89 rubles. You shouldn't buy expensive imported fillers, it's a waste of money.

Silica gel is a substance that absorbs moisture well. He literally pulls it out of the environment. The substance is packaged in small bags and placed in the packaging with shoes. It is also sold in the form of anti-damp tablets. Place the tube in silica gel for 12 hours - during this time it will draw out all the water.

It is not recommended to use salt to absorb moisture. If it gets inside the phone, it will accelerate the corrosion of elements and conductive paths on the printed circuit board.

How to dry your phone at home

An absorbent is a substance that draws and absorbs moisture. Whichever method you choose, you will need a container to place both the product and your phone. Drying rules for each method are below:

Put the phone in the rice. This is the most famous absorbent. The fact that you can dry your phone in rice is not a myth; this remedy is effective. Place the gadget without battery and cover in a bag of cereal for 2-3 days. Turn the device over once every 12 hours.
Use silica gel cat litter. This product is considered an even better absorbent than rice. To dry the gadget, place it in a container with filler for 48 hours. In this case, the product should completely cover the device. Turn your smartphone over from time to time.
Dry your phone in silicone shoe balls. An alternative option, similar in effectiveness to the previous one. Draws out moisture in 2 days.

Advice that applies to all methods: check your smartphone every 6 hours and wipe off moisture from its surface with paper napkins. In addition, in case of severe damage, you can replace the absorbent with a new one.

What to do if a store discovers that you have a counterfeit bill
How to recover and read deleted messages
Surprisingly, these 15 things are draining your energy and vitality.

What is prohibited to do

The rules are simple:

You should not dry your phone in the oven - it will not withstand such heat (the minimum temperature in the oven is about +80 degrees).
Do not place the handset in a microwave oven.
Do not wipe the tube with alcohol - it is unlikely to draw out any remaining moisture.
Do not place the phone on a heating pipe - its temperature may be too high.

Batteries are most afraid of overheating - there is a high probability of explosion.

Is it possible to dry your phone with a hairdryer or vacuum cleaner?

A regular hairdryer will help you dry your phone at home. Set the minimum temperature, direct a stream of air at the device - the moisture will begin to evaporate more intensely. There are also opinions that a hair dryer does not remove moisture, but forces it to penetrate deep into the device, accelerating corrosion.

Before you try to dry your phone with a vacuum cleaner, shake out any large drops of water from it. Place the plastic nozzle on the hose, turn on the vacuum cleaner, and bring the device to the “drowned man”. Air currents will help draw out remaining moisture. Do not touch the nozzle to the gadget to avoid its failure - powerful air currents electrify the hose with the nozzle, causing the accumulation of static electricity. Static can damage electronics.

How to dry a water-damaged phone: advanced methods

A device that has fallen into water can dry out on its own. It is enough to disconnect the battery and other elements, lay it on a soft towel and leave it for a while to dry. However, you can speed up this process and help a phone that has been damaged by water. It is also available at home. To dry the gadget, you need to use one of the following methods:

1. Rubbing with alcohol. It combines with water and helps it dry faster due to the fact that such a solution evaporates in a shorter period of time.

2. Collect moisture with a vacuum cleaner. This is perhaps the fastest way to help a mobile phone that has been drowned. Each part must be blown out for about twenty minutes. However, if contact with moisture has been prolonged, then this method is unlikely to be effective.

3. Use of substances that absorb water. One of the most budget-friendly is rice. It absorbs moisture, and therefore the recessed mobile phone can be left in a sealed bag or container with this cereal overnight. Also suitable is silicone gel in granules, which can be found in all boxes of new shoes.

Important! You should not dry your device with a hairdryer. Even the gentle mode can damage your smartphone. In addition, the very direction of the air flow contributes to deeper penetration of water into the device.

After all the necessary steps have been taken, the cell phone must be left for at least a day to dry. It is best when it lies on the sunny side and soft towels for a while, even after being placed in a container with rice or silicone gel.

How to dry your smartphone

Turn off the power. Wipe the device with paper napkins to collect moisture from the outside of the case.
If the case design allows it, remove the cover and remove the power source. Otherwise, remove the card tray.
Leave your phone in a dry place to dry. It is advisable to cover the device with silicate gel sachets, which are usually found in shoe boxes. Silicate gel collects moisture well, which will help partially remove moisture inside the smartphone.
If silicate gel is not available, place the apparatus in dry rice. It is believed that rice absorbs moisture well. Make sure that rice does not fall into the hole for installing the tray with cards.
Contact a service center or repair shop to have your phone sent for cleaning.

Water got into the phone's camera, what should I do? The camera on the phone fogs up from the inside - what should I do?

In today's mobile devices, the “call” function has moved to the outermost places in popularity. After all, now the phone has turned into an address book, a TV set, a player and, of course, a camera. The quality of photography and video shooting is improving with each new model, and at the moment this quality has reached almost 4K properties, which makes the phone a professional camera.

However, there are cases in which the phone's camera either works intermittently or fogs up. It’s the camera dilemma where the phone’s camera fogs up from the inside that’s worth talking about. Why condensation occurs in the chamber, how to avoid it and how to correct the situation.

Danger of condensation and first steps

If condensation forms on the camera lens, it is important to know how to solve this problem in such a way as not to break the phone and not destroy its performance. After all, some of the water will be able to move from under the camera lens to the inside of the phone.

At best, this can lead to blurred photos and videos being created, and at worst, it can lead to damage to the camera or the entire phone as a whole. But removing condensation from your phone camera is much easier than it seems.

The first and probably most common method among users is to dry the phone in rice. In order to do this, you only need to have two items available - snow-white dry rice and a plastic bag.

In order to dry your phone and get rid of fogging in the camera, you need to follow these steps:

Get everything you can out of your own phone, that is, remove the battery, SIM cards and memory card.
Fill the bag 50 percent with white dry rice. Rice is distinguished by one fundamental individuality - it can quickly absorb any kind of water, including even that which is covered by a telephone. Rice can also draw condensation out of your phone and camera lens.

Phone in rice
After this, you need to put the phone in the rice and close the bag overnight. The phone needs to be left alone all night.
After the phone spends the night in the bag, you need to take it out of the bag and put all the components in place.

How to remove moisture and dry - all methods

There are a number of actions that can be taken immediately after removing a mobile device from the water, thanks to which the consequences of getting it wet are not so dire. And you should always start with safety, for which you must immediately (every second can be decisive) turn off the power to the device. If the battery is not removable, then do this by long pressing the lock button. With a removable battery it is easier; you need to quickly remove it along with the SIM card and SD card in order to save the information stored on them.

Then remove the phone from the case and protective glass. In this case, it is worth holding it exactly in a horizontal position with the screen up, so that the water flows under the force of its gravity to the back wall of the device. Where possible, it is better to blot away moisture with whatever is at hand (paper towel, napkin or rag). The main thing is that there is no lint on them. After removing the water, which is visible to the naked eye, all that remains is to dry the mobile device.

Important! A device left in the air will dry naturally within a few days, but this does not guarantee its ability to be used in the future.

Under the influence of water (more precisely, salt impurities in it), the contacts can oxidize. There are several ways to speed up the drying process. They all involve the use of certain bulk products that absorb moisture.

Depending on what can be applied at the moment, one of the following methods will be suitable:

Pour dry rice cereal into a plastic container of a suitable size or a plastic bag and place the wet phone in it. You should also dry the removable battery in rice. If you don't have rice, you can use coarse salt. For the best effect, you should turn the device twice a day.
Rice and salt are used more out of habit, although it has already been proven that silica gel (balls from boxes of shoes or electronics) absorbs moisture three times more. After initial manipulations (for example, drying with a hairdryer), it is worth keeping the “drowned man” in a closed container with silica gel, which will draw moisture from the most inaccessible places of the device.
Pet litters are considered effective absorbents.
Dipping the device into medical alcohol for a few seconds will help speed up drying. Ideally, of course, it is better to remove the display module, speaker and microphone in advance.

What can't you do?

To avoid causing even more damage to a phone that has fallen into the water, you should know what exactly you should not do:

Try to turn on a partially dry device.
Disassemble the device without knowing how to do it.
You should not make sudden movements, much less shake the gadget, trying to pour water out of the connectors. This may cause the liquid to penetrate deeper into the device.

Attention! When drying, use a hairdryer, and especially do not put the gadget in the microwave, after which it will turn into useless trash. Since different components of the device have a certain threshold of permissible temperatures.